Pressure Washer Water Pump Maintenance



Pressure washer water pumps need relatively low oil recommended by the manufacturer, as specified in the owner's manual. (Purchase pre-measured bottles of pump oil for water pumps without dipsticks.) Never use special oil additives or detergents, unless specified in the owner's manual.

Pressure Washer Water Pump Maintenance

Step 1 - Purging the pump of contaminants. Prepare the pressure washer for use. Turn on the supply water, then remove the wand from the spray gun. Start the engine, then squeeze and hold the spray-gun trigger until there is a constant, steady stream of water. Hold for 2 minutes, then engage the trigger safety latch and refasten the wand to the spray gun.

Pressure Washer Water Pump Maintenance

Step 2 - Changing pump oil. Drain the oil and fuel from the engine. Remove the oil cap on the water pump with an Allen wrench. Tilt the pressure washer to drain the used oil into an approved container. Tilt the unit back in the opposite direction after the oil has drained.

Pressure Washer Water Pump Maintenance

Step 3 - Changing pump oil. Fill the water pump with fresh oil, following the directions in the owner's manual. Note: Premeasured bottles of water pump oil are available for some models. Reinstall the oil cap and tighten firmly, then wipe up any excess oil around the cap and set the pressure washer in the upright position. Clean up any spilled oil, and dispose of used oil and soiled rags in accordance with local environmental statutes.

 

See also Preventative Pressure Washer Maintenance


Shop Related Maintenance Parts


TROUBLESHOOTING FAQS

View solutions for handling the most common engine and product troubleshooting and maintenance questions.

View FAQs >

VIDEOS

Videos

Learn about the latest products by Briggs & Stratton, step-by-step instructions on how to locate your lawn mower engine model number and more!

Browse Videos >