My Account Briggs & Stratton My Cart (0)

Oil Filter Extended Life Installation Instructions
Share |

Posted In

Oil Filter Extended Life Installation Instructions
For Service Part No. 696854 / DIY Part No. 5076

FITS ENGINES:                                                                    
12.0-30.0 Gross HP/CV‡
Extended Life Series™
Professional Series™

1. Before installing new filter, follow the oil change procedure in the operator's manual
2. Lightly oil gasket with fresh clean engine oil
3. Screw filter on by hand until gasket contacts filter adapter.
4. Tighten 1/2 to 3/4 turn farther.

See operating manual for oil filter maintenance information.

‡All power levels are stated gross horsepower at 3600 rpm per SAE J1940 as rated by Briggs & Stratton

I have  new 22 hp john deere, what size of oil filter do I need

Asked by: Markos

My engine is a 24 hp Intek V-twin. How do I reset the engine hour meter "change oil" message? I changed the oil at 50 hours and the oil and filter at 100 hours, and now at 150 hours the oil again, but the hour meter still flashes change oil.

Asked by: gdub
The hour meter in a part of the equipment the engine is on. Please contact the equipment manufacture to determine how to reset the maintenance meter.
Answered by: Nicole_BriggsStratton
Date published: 2014-06-06

are part numbers 696854 and 492932 interchangeable

Asked by: jaybob
Yes, 492932 is the standard and 696854 is the extended life filter.
Answered by: Nicole_BriggsStratton
Date published: 2014-05-10

How do I know if my mower engine should have an oil filter.  My manual says it should but I cannot find it.  The B&S engine is a 31A607 0741 B2.  But even that manual says it may or may not have an oil filter.  Is there a way to check for sure?

Asked by: DadF
This engine was made with and without a filter. You need to look at the sump of the engine for the filter.
Answered by: Nicole_BriggsStratton
Date published: 2014-04-28

Bought an older used mower with a B&S 21hp V-twin. It has no oil filter, but has a small oil filter shaped cap about 3/4 inch in depth where the oil filter is installed on my other B&S V-twin - can the cap be removed and a regular oil filter installed?

Asked by: MowinMan
To locate any information on your engine, you will first need the model type and code. Please see the following FAQ for assistance in locating these numbers: Once you have this information you can find information on your engine here: Select engine as your product type and follow the directions for entering the model type and trim into the search fields.
Answered by: Nicole_BriggsStratton
Date published: 2014-04-22

Where on the mower is the oil filter located ?

Asked by: Bruce05
Some small engine may not have an oil filter. If the engine is equipped with an oil filter it is located near the bottom of the engine attached to the engines sump.
Answered by: Nicole
Date published: 2013-10-28

Our Starting Promise

Briggs & Stratton Starting Promise

Learn more about our Starting Promise today. 

Learn More »

0 Items in Your Cart

Estimated Price: 0.00