REGION: LANGUAGE:
My Account Briggs & Stratton My Cart (0)

Air Filter & Pre-Cleaner (Service Part 493537S) Installation Instructions


Share |

Posted In


Air Filter Pre-Cleaner Installation Instructions
Service Part No. 493537S / DIY Part No. 5064

FITS ENGINES:
8.25-15.75 ft-lbs Gross Torque†, 825-1575 Series™
3.5-6.75 Gross HP/CV‡ Quantum®
5.5-7.0 Gross HP/CV‡ Horizontal Shaft
5.5-11.0 Gross HP/CV‡ OHV/Intek™

Use with Part No. 5043 Air Filter Cartridge


1. Remove air filter cover screw
2. Remove air filter cover
3. Remove air filter cartridge and pre cleaner
4. Clean any debris from base assembly then install new parts in reverse order.

NOTICE: Tabs must be visible through slots to ensure proper installation. Improper installation will cause damage to engine.

See operating manual for air filter maintenance information.

†All power levels are stated gross torque at 2600 rpm per SAE J1940 as rated by Briggs & Stratton

‡All power levels are stated gross horsepower at 3600 rpm per SAE J1940 as rated by Briggs & Stratton

My mower runs but is blowing blue smoke.  What would cause this?

Asked by: Knith

placement of pre cleaner - foam side up or screen side up?

Asked by: JimmyN

what is going on when the engine start up asnd off about one second.

Asked by: BrianC
This is typically caused by a clog in the carburetor and it will need to be overhauled.
Answered by: Nicole_BriggsStratton
Date published: 2014-04-28

what is going on when oil is coming from the exhaust vent

Asked by: BrianC
This is either because the oil is overfilled or fuel has gotten into the oil.
Answered by: Nicole_BriggsStratton
Date published: 2014-05-13

is the a manual for the 35 classic petrol engine? 

Asked by: philpot30
To locate any information on your engine, you will first need the model type and code. Please see the following FAQ for assistance in locating these numbers: http://bit.ly/17rzznN Once you have this information you can find information on your engine here: http://bit.ly/12pIs1I Select engine as your product type and follow the directions for entering the model type and trim into the search fields.
Answered by: Nicole_BriggsStratton
Date published: 2014-05-30

how do you drain the oil out of the engine (small push engine)

Asked by: bender
There may be a recessed drain plug on the underside of the engine; however, the equipment manufacturer may have covered this when they installed the engine on their mower. If this drain is blocked you can tilt the engine to its side to drain from the oil fill. When tilting the unit, make sure you remove the gas and tilt fuel tank side up.
Answered by: Nicole
Date published: 2014-05-18

how to drain the carburetor

I need to drian all the fuel from my lawnmower. How do I do this?
Asked by: Jackeyes
You will want to use a fuel extractor or siphon the fuel from the unit.
Answered by: Nicole
Date published: 2014-05-30

free repair manual 4hp. push mower

Asked by: preston23
Repair manuals are only available in hard copy for purchase here: http://bit.ly/14yUsl2
Answered by: Nicole
Date published: 2013-10-15







Our Starting Promise

Briggs & Stratton Starting Promise

Learn more about our Starting Promise today. 

Learn More »

0 Items in Your Cart

Estimated Price: 0.00